Electrolux ES200 important safety instructions Setting Surface Controls, Using proper cookware

Setting Surface Controls

Using proper cookware

The size and type of cookware used will influence the setting needed for best cooking results. Cookware should have flat bottoms that make good contact with the entire surface heating element (See Fig. 1). Check for flatness by rotating a ruler across the bottom of the cookware (See Fig. 2).

	Be sure to follow the
	recommendations for using
	proper cookware as illustrated in
	Figs. 1 & 2. For more information
	about the ceramic cooktop see
	“Cooktop Cleaning &
	Maintenance” in the General
Fig. 2	Care & Cleaning section.

To Operate Single Radiant Surface Elements

Fig. 1

To Operate a Single Radiant Element:

1. Place correctly sized cookware on radiant surface element.

2.Push in and turn the surface control knob in either direction to the desired setting (Refer to the Suggested Radiant Surface Element Settings Table, Figs. 3 & 4). Start most cooking

operations on a higher setting and then turn to a lower setting to finish cooking. The surface control knobs do not have to be set exactly on a particular mark. Use the marks as a guide and adjust the control knob as needed. Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area.

3. When cooking is complete, turn the surface element OFF before removing the cookware.

	Note: The Element On indicator lights will glow when one or more elements are turned ON. A quick
	glance at these indicator lights when cooking is finished is an easy check to be sure all control knobs
Fig. 3	are turned OFF. The Hot Surface indicator light will continue to glow AFTER the control knob is turned
	to the “OFF” position and will glow until the heating surface area has cooled sufficiently.

Suggested Radiant Surface Element Settings Table

RADIANT SURFACE ELEMENTS

Setting Type of Cooking

The suggested settings found in Fig. 4 are based when cooking with medium-weight aluminum pans with lids. Settings may vary when using other types of pans.

Note: The size and type of utensil used, and the amount and type of food being cooked will influence the setting needed for best cooking results.

HIGH (HI - 9)	Start most foods, bring water to a boil, pan broiling
MEDIUM HIGH (7 - 8)	Continue a rapid boil, fry, deep fat fry
MEDIUM (5 - 6)	Maintain a slow boil, thicken sauces and gravies or
	steam vegetables
MEDIUM LOW (2 - 4)	Keep foods cooking, poach, stew
LOW (LO - 1)	Keep warm, melt, simmer
	Fig. 4

Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.

Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed

too close to the surface elements.

Do not allow aluminum foil, or ANY material that can melt to make contact with the ceramic glass cooktop. If these items melt on the cooktop they will damage the ceramic cooktop.

8