Electrolux ANC 822, ESF 631 manual Dishwashers That Can Be Inte- grated, Built-In Dishwasher

Depending on type, the dishwasher is to be installed as follows:

Dishwashers That Can Be Inte- grated

(see installation template supplied)

3The door of the appliance can be fitted with a wooden furniture door with the following dimensions

Width:	591 – 594 mm
Thickness:	16 – 24 mm
Height:	dependent on	- Recess height
(variable)		- Plinth height
		- The adjustment so that the unit matches the height
		of the adjoining units
		The exact height of the adjoining units must be
		measured at the place of installation.
Weight:	max. 8 kg

1If the facing panel is longer than 600 mm, the door of the appliance cannot be opened completely (the facing panel bumps against the plinth).

If this is the case, the plinth must be cut out (see installation template) or the brace adapter for the extra long door BLT 60 must be used. You can obtain this with the E No. 911 239 008.

Built-In Dishwasher

(see enclosed installation instructions)

Free-Standing Appliances

1can be set up as stand-alone without addi- tional installation.

If the dishwasher is set up next to a cooker, a heat-insulating, non-flammable plate must be mounted between the dishwasher and the cooker, flush to the top edge of the work sur- face (depth 57.5 cm). The plate should have aluminium foil on the side facing the cooker.

If the dishwasher is installed underneath a kitchen work surface, the original work surface of the dish- washer is to be removed as follows:

1.Unscrew the screws (1) from the elbows on the back side.

2.Slide the work surface approx. 1 cm to the rear (2), lift at the front (3) and remove.

3.Press the work surface retaining brackets at the position (4) shown in the diagram and remove the bracket at an angle to the rear (5).

4

5

25