The water softener must be set in both ways: manually, using the water hardness dial and electronically, using some of the programme buttons on the control panel
Setting manually
The dishwasher is factory set at position 2.
1.Open the dishwasher door.
2.Remove the lower basket from the dishwasher.
3.Turn the water hardness dial to position 1 or 2 (see table).
4.Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
1.Press the On/Off button. The dishwasher must be in setting mode.
2.Press simultaneously and keep pressed buttons 2 and 3, until the lights of buttons 1, 2 and 3 start flashing.
first use electrolux 13
3.Press button 1, the lights of buttons 2 and 3 turn off while the light of button 1 goes on flashing. In the digital display is visible the current level and a sequence of intermittent audible signals are heard.
The current level is indicated by the number visible in the digital display and the number of intermittent audible signals.
Examples:
displayed, 5 intermittent audible signals, pause, etc... = level 5
displayed, 10 intermittent audible signals, pause, etc... = level 10
4.To change the level, press button 1. Each time the button is pressed the level changes. (For the selection of the new level see the chart).
Examples:
if the current level is 5, by pressing button 1 once, level 6 is selected. if the current level is 10, by pressing button 1 once, level 1 is selected.
5.To memorise the operation, switch off the dishwasher by pressing the On/Off button.
