Operating sequence
1. Check the filters | 8. Start the programme |
Ensure they are clean and properly positioned | Depress the On/Off pushbutton and close the |
(see cleaning instructions). | door; the machine will start. |
2.Check that there is rinse aid and salt
3.Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.
Slide the basket back into the machine.
4.Ensure that the spray arms can rotate freely.
5.Measure out detergent
Add the required amount of detergent into the dispenser according to the "Washing programmes" chart and close the lid.
6.Close the detergent dispenser lid
7.Select the programme
The selection of a programme occurs with the door partially opened.
Turn the programme selector dial clockwise until the number of the programme you wish to select corresponds with the programme marker on the control panel.
9. At the end of the washing programme
At the end of the washing programme the dishwasher stops automatically.
10. Switch off the dishwasher
Open the door and switch off the dishwasher by pressing the On/Off pushbutton.
When the wash programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.
In general it is not advisable to open the door while the machine is working;if the door is opened however, a safety device ensures that the machine stops.
Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape.
14 | POS03UK |
