ΦTo carry out complete defrosting:
1.Disconnect the appliance from the electrical supply. If the plug is inaccessible turn the thermostat control knob to „0“.
2.Remove any stored food, wrap in several layers of newspaper and store in a cool place.
3.Leave the door open.
4.Carefully draw the plastic drain spout out of the lower part of the appliance according to the direction of the arrow and place a tray of a suitable size in the position shown.
5.During defrosting, push the defrost water towards the edge of the cooling plates using a dry cloth or a sponge. It will be collected at the bottom of the appliance, from where it can be diverted into the tray and then disposed of.
6.To accelerate the defrosting process place a bowl of hot (not boiling) water inside the freezer and close the door.
7.When defrosting is completed, dry the interior thoroughly, replace the drain spout and close the door.
8.Turn the thermostat control knob back to a medium setting and leave to run for at least 4 hours with the 'fast freeze' switch on.
9.Replace the previously removed food.
Important
A temperature rise of the frozen food packs during defrosting may shorten their safe storage life.
Never use sharp metal tools to scrape off frost from the evaporator as this could damage the appliance beyond repair.
Something Not Working
If the appliance is not working correctly, please carry out the following checks before contacting your local Electrolux Service Force Centre.
Problem | Possible Cause | Solution |
|
|
|
No power to the | No power at the socket. | Check there is power at the socket. |
appliance | There is a power cut. | Check there is not a power cut by checking the |
| ||
|
| household lights. |
| The fuse has blown. | Check the fuse has not blown. |
| Thermostat control is set at „0“. | Check the thermostat setting. |
|
|
|
The temperature in the | The appliance is located in an unsuitable position. | Check the ambient temperature is within the |
appliance is too high |
| appliances operating limits of 16 °C to 32 °C. |
| The thermostat control is set too low. | Check that the thermostat control knob is turned to |
|
| the correct setting relative to ambient conditions. |
|
|
|
The temperature in the | The thermostat control is set too high. | Set the thermostat control knob to a lower |
appliance is too low |
| position. |
|
|
|
Excessive frost and ice | The door has been left open. | Check the door has not been left open. |
has built up | Something is obstructing the door. | Check nothing is preventing the door from closing. |
| ||
| The door gasket is dirty. | Check the door gasket is intact and clean. |
|
|
|
The appliance is noisy. | The appliance is not level. | Check if the appliance stands stable (all four feet |
|
| should be on the floor). |
If after the above checks your appliance still does not operate correctly, contact your local Electrolux Service Force Centre.
Please note that it will be necessary to provide proof of purchase for any
10