Standpipe | Electrolux EWD 1409 I specification

If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system.

There should be a minimum distance of 5.02m

(16.5 ft) between the appliance’s inlet and the bottom of the water storage tank.

Set the hoses correctly by loosening the ring nuts. After positioning the inlet hoses, be sure to tighten the ring nuts again to prevent leaks.

When discharging into a standpipe ensure that the top of the standpipe is no more than 90cm (35.4'') and no less than 60cm (23.6'') above floor level.

3 pin
60 cm (23.6”)	Max. 90 cm (35.4”)

P1088

P0021

Min.

P1039

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Centre.

The joining piece must have an internal diameter of 18mm.

If your drain hose looks like this (see below) you do not require the “U” piece”. Just push the hose firmly into

Water drainage

This appliance is designed to be permanently plumbed into your home's drainage system using one of the following methods.

1. Into a drainage standpipe.

Firstly form a hook in the end of the drain hose using the “U” piece” supplied.

“U” piece supplied

P1199

TPlace the drain hose into your standpipe, which should have an internal diameter of approximately 38mm thus ensuring there is an air break between the drain hose and standpipe.

38 mm (11.2”)

standpipe diameter

cm30 ")2(1

P1074

the standpipe.

P1212

2. Onto a sink outlet spigot.

If the outlet spigot has not been used before, remove any blanking plug that may be in place.

P1197

Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is formed in the drain hose (see diagram) to prevent waste from the sink entering the washer dryer.

EWD 1409 I specifications

The Electrolux EWD 1409 I is a versatile and efficient washer-dryer that caters to the needs of modern households. This innovative appliance stands out for its combination of advanced technology, energy efficiency, and user-friendly features, making laundry a far more manageable task.

One of the standout features of the EWD 1409 I is its impressive washing capacity. With a maximum load of 9 kg for washing and 5 kg for drying, it strikes a fine balance between catering to small and large loads without compromising on performance. The washer-dryer is equipped with various washing programs, including delicate, cotton, and synthetic cycles, ensuring that all fabrics are cared for appropriately. It also features a quick wash option, allowing users to clean lightly soiled items in just 20 minutes.

The EWD 1409 I incorporates cutting-edge technology to enhance cleaning performance. Its innovative sensor technology automatically detects the load size and adjusts water and energy consumption accordingly, promoting efficiency and sustainability. This appliance boasts an A-rated energy efficiency classification, helping families reduce their carbon footprint while saving on utility bills.

In addition to its efficient washing capabilities, the EWD 1409 I also excels in drying performance. The integrated drying function utilizes a heat pump system, a gentler method that minimizes fabric wear while ensuring effective moisture removal. This technology makes it suitable for a wide range of fabrics, providing peace of mind that clothes will come out dry and unharmed.

User convenience is also a priority in the design of the EWD 1409 I. Its intuitive control panel features a digital display, allowing users to easily select programs and monitor the progress of the wash and dry cycles. The delay start option is particularly useful for those with busy schedules, enabling users to schedule their laundry to start at a later time.

With its modern design and compact dimensions, the Electrolux EWD 1409 I fits seamlessly into any home environment. Its combination of efficiency, performance, and user-friendly features makes it a valuable addition to any laundry room, meeting the needs of users while enhancing the overall laundry experience.

Electrolux EWD 1409 I manual Joining piece must have an internal diameter of 18mm, Standpipe

Models: EWD 1409 I