30electrolux Something not working
Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes, one of the following alarm codes appears on the display and at the same some acoustic signals sound every 20 seconds to indicate that the machine is not working:
●E10: problem with the water supply
●E20: problem with water draining
●E40: door open.
Once the problem has been eliminated, press the Start/Pause button to restart the programme. If after all checks, the problem persists, contact your local Service Centre.
Malfunction | Possible cause | Solution |
The washing machine does not start:
The machine fills then empties immediately:
The machine does not fill:
●The door has not been closed. E40
●The plug is not properly inserted in the power socket.
●There is no power at the socket.
●The main fuse has blown.
●The selector dial is not correctly positioned and the Start/Pause button has not been depressed.
●The «Delay Start» has been selected.
●The end of the drain hose is too low.
●The water tap is closed.
E10
●The inlet hose is squashed or kinked. E10)
●The filter in the inlet hose is blocked. E10
●The door is not properly closed. E40
●Close firmly the door.
●Insert the plug into the power socket.
●Please check your domestic electrical installation.
●Replace the fuse.
●Please turn the selector dial and press the Start/Pause button again.
●If the laundry are to be washed immediately, cancel the delay start.
●Refer to relevant paragraph in “water drainage” section.
●Open the water tap.
●Check the inlet hose connection.
●Clean the water inlet hose filter.
●Close firmly the door.
