The drain hose may be extended to a maximum of 4 metres.

3 pin

 

 

(35.4”)

60 cm (23.6”)

Max. 90 cm

Min.

 

HEC0012

 

An additional drain hose and joining piece is available from your local Service Force Centre. The joining piece must have an internal diameter of 18 mm.

If your drain hose looks like this (see below) you do not require the «U» piece. Just push the hose firmly into the standpipe.

P1212

2. Onto a sink outlet spigot.

If the outlet spigot has not been used before, remove any blanking plug that may be in place.

P1197

installation electrolux 43

Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is formed in the drain hose (see diagram) to prevent waste from the sink entering the washing machine.

Loop

P1198

Important!

Before connecting the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes.

Special conditions

If the floor is carpeted or covered with crumbly or soft material, insert a rigid support base under the feet to prevent noise, vibration or displacement. The base should protrude a few centimetres beyond the edges of the machine.

Warning !

The machine should NOT be placed on deep pile carpeting.

Page 43
Image 43
Electrolux EWN 14991 S, EWN 14991 W user manual Onto a sink outlet spigot, Special conditions