When Eco rinse is used, rinse water is
sprayed into the washbowl in pulses.
After each pulse the washbowl will spin
to remove detergent laden water from
the clothes.
The machine will go through a series of
maximum six pulse spray and short
spin cycles in this manner, depending
on program selection, followed by a
final long spin that removes the water
from the clothes to complete the full
wash program.
Compare this with Deep rinse where
much more water is used.
Deep rinse, water enters the
machine filling up to the wash water
level selected. The washer agitates
and finally empties the rinse water
through the drain hose.
How does Eco Rinse work ?
Before you start the
program, this option
makes it possible to define
the end of the washing
program by 2, 4, 6 and 8
hours. This option MUST
be selected after choosing
the wash program with
the dial, and before
pressing the “Start/Hold
To Pause” button.
If after having set the Delay-End option
(and pressed “Start/Hold To Pause”
button) and you wish the cancel or
modify it, follow the below steps:
set the washing machine to PAUSE
by press and hold the “Start/Hold
To Pause” button for 1.2 seconds
Delay End Option
Extra rinse, this is special option for
those people who suffer from allergies,
this extra rinse will provide two deep
rinses to ensure all detergent residue
has been removed.
Eco Rinse and Fast Rinse CANNOT
be selected with Woollens, Bedding
and Tub Cleaning program.
If your water flow rate is too low
(low water pressure). You should
avoid ‘Eco’ and ‘Fast’ rinse,
because the rinse performance
will drop.
You can use ‘Delay End’ option to
make machine start to run when water
flow rate is too high (e.g. If your coutry
have high water pressing on eairly
morning you can run the machine on
that time).
Select Deep rinse if you are going to
use fabric softener.
Deep rinse ensures the fabric softener
is correctly dispensed and thoroughly
removed from your clothes during
rinsing.
Extra/Eco/Fast rinse is not
designed to be used with fabric
softener.
1.
deselect the Delay-End option,
changing the status
2.
press the “Start/Hold To Pause” to
start the program.
3.
16