Problem | Possible cause |
electrolux 9
Solution
Water flows on the rear plate of the refrigerator.
Water flows into the re- frigerator.
Water flows on the ground.
The product temperature is too high.
The room temperature is too high.
During the automatic defrosting process, frost defrosts on the rear plate.
The water outlet is clogged.
Products prevent that water flows into the water collector.
The melting water outlet does not flow in the evaporative tray above the compressor.
Let the product temperature de- crease to room temperature before storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch the rear plate.
Attach the melting water outlet to the evaporative tray.
The temperature in the appliance is too low.
The temperature in the appliance is too high.
The temperature in the re- frigerator is too high.
The temperature in the freezer is too high.
There is too much frost.
Replacing the lamp
The temperature regulator is not set correctly.
The temperature regulator is not set correctly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the same time.
There is no cold air circulation in the appliance.
Products are too near to each other.
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not set correctly.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de- crease to room temperature before storage.
Store less products at the same time.
Make sure that there is cold air cir- culation in the appliance.
Store products so that there is cold air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
1.Disconnect the mains plug from the mains socket.
2.Remove the screw from the lamp cover.
3.Remove the lamp cover (refer to the illus- tration).
4.Replace the used lamp with a new lamp of the same power (the maximum power is shown on the lamp cover).
5.Install the lamp cover.
6.Tighten the screw to the lamp cover.
7.Connect the mains plug to the mains socket.
8.Open the door. Make sure that the lamp comes on.
