Symptom |
| Possible Cause |
| Remedy |
|
|
|
|
|
The freezer temperature is not sufficient, red light lights up, temperature alarm sounds
Heavy build up of frost, possi- bly also on the door seal.
The compressor does not start immediately after changing the temperature setting.
Temperature is not properly adjusted.
Door was open for an exten- ded period.
A large quantity of warm food was placed in the appliance within the last 24 hours.
The appliance is near a heat source.
Door seal is not air tight (pos- sibly after changing over the hinges).
This is normal, no error has occurred.
Please look in the "Initial Start Up" section.
Open the door only as long as necessary.
Press the fast freeze switch
Please look in the "Installation location" section.
Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. 50 °C). At the same time shape the warmed door seal by hand until it sits cor- rectly.
The compressor starts after a period of time.
If, after carrying out the necessary checks there is still a fault with your appliance please contact your local AEG Service Force Centre.
In guarantee customers should ensure that the suggested checks have been made as the engineer will make a charge if the fault is not a mecha- nical or electrical breakdown.
Please note that proof of purchase is required for any
15
