Electrolux - Gibson 240435505 To Properly Install Your Refrigerator, Refrigerator does not run

ATTENTION

To Properly Install Your Refrigerator

See “Installation” Section On Pages 4-5

OR

To Reverse The Doors

See “Door Removal & Reversal” Section On Pages 6-7

Before You Call

Common	Before calling for service, review this list. It may save you time and
	expense. This list includes common occurrences that are not the result of
Occurrences
	defective workmanship or materials in this appliance.
	• Ensure plug is tightly pushed into electrical outlet.
Refrigerator does not run.	• Check/replace fuse with a 15 amp time-delay fuse. Reset circuit
		breaker.
	• The temperature control is turned to "O".
	• Refrigerator may be in defrost cycle. Wait 20 minutes and check again.
Freezer temperature too cold.	•	Set freezer control to a warmer setting until freezer temperature is
Refrigerator temperature is		satisfactory. Allow 24 hours for the temperature to stabilize.
satisfactory.
Refrigerator temperature too cold.	•	Set refrigerator control to a warmer setting. Allow 24 hours for
Freezer temperature is		temperature to stabilize. Then check freezer temperatures and adjust
satisfactory.		as needed.
* Refrigerator is noisy or vibrates.	• The cabinet is not level.
	•	Floor is weak.
Odors in refrigerator.	• Interior needs to be cleaned.
	• Foods that produce odors should be covered or wrapped.
	•	Replace light bulb.
Cabinet light not working.	• Ensure plug is tightly pushed into electrical outlet.
	• Light switch may be stuck. Push in light switch, located on the
		refrigerator control box, to release.
	• Ensure the Wire Signal Arm is not in UP position.
Automatic ice maker not working.	•	Ice maker should produce 4 to 5 pounds of ice in a 24 hour period.
	• Water supply is turned off.
(some models)

•Water pressure is too low.

•The freezer is not cold enough.

*See Normal Operating Sounds and Sights section on page 14.

19