Wall unit mounting - Fig. 6
First decide how the hood is to operate (extractor or filter).
If you decide to use the hood in the extractor version we suggest to position the upper section of the chimney so that the oulet slots are not visible once installed, if the hood is used in the filtering version ENSURE that the side with the slots pointing upwards (see also
B
180°
A
C - OK!
Fig. 6
Wall unit mounting - Fig. 7
•Mark the wall with a centre line, this will aid mounting procedure (1), position the template so that the mid line printed on the template matches with the centre line previously drawn, the lower side of the template corresponds to the lower side of the hood once mounted
(2).
•Drill two holes Ø 8mm and fix the support bracket with two wall plugs and screws (3). Hang the hood (4) and adjust its position (5- 6).
•From the inside of the hood mark two points for fixing (7).
•Remove the hood (8) and drill two holes Ø 8mm (9), fit two wall plugs (10).
•Drill two holes Ø 8mm on the upper side close to the ceilling, fit two wall plugs (11) (In case the hood is to be used in filter version, mount the deflector F on the chimney support with four screws 2,9x6,5 (Two screws for model DD 8820 - HD 8820) and fix the chimney support G with two screws (12).
•Hang the hood again (13) and secure it with two screws (14).
•Fit an exhaust pipe (15) to connect the outlet hole A of the hood to the outside (Extractor hood) or to the deflector F (Filter version).
•Make electrical connection (16).
•Fix the chimney first up (17a) to the chimney support (17b), then slide the lower section of the chimney down into the housing on top of the hood (18).
•Only for model DD 8820 - HD 8820: Fix the lower section to the hood with two screws 3 x 9 mm (19).
66
