Electrolux LAVAMAT 74810 manual Flashes 1x, and an

Problem	Possible cause	Remedy
E10 appears.	Tap turned off.	Turn on the tap.
The END indicator	The filter in the threaded	Turn off the tap. Unscrew the
flashes 1x, and an
		hose, take out the filter and
acoustic signal sounds	inlet hose fitting is blocked.
		clean it.
1x.
(Problems with water	Water tap is furred with	Check the tap and have it
inflow.)	lime scale or is faulty.	repaired, if necessary.
	The transit packaging has	Removing the transit
The washing machine	not been removed.	packaging.
vibrates when operating	The screw feet not correctly	Adjust the feet as described
or is not stable.
		in the installation and
	adjusted.
		connection instructions.
Washing has not been	Only a few large items of	Always load the drum as full
		as possible. Mix large and
spun.	washing in the drum.
		small items.
	Screw connection on the	Screw the inlet hose on
	inlet hose is leaking.	tightly.
	Drain hose is leaking.	Replace drain hose.
Water is running out	Drain pump cover is not	Close the cover properly.
from under the washing	closed properly.
machine.	Washing was caught in the	Load washing carefully for
	door.	the next wash.
	Emergency drain hose is	Close off emergency drain
	leaking.	hose properly.
Wash water is foaming
excessively. At the end		Follow the manufacturer's
of the washing cycle,	Too much detergent has
		instructions exactly when
the spin stops. The	probably been used.
		measuring out detergent.
OVERDOSING indicator
lights up.
	Kink in drain hose.	Straighten the hose.
	Do not exceed the	Please contact customer
E20 appears.	maximum pump height of
		service.
	1m.
The END indicator
flashes 2x, and an		Switch off the appliance.
acoustic signal sounds
		Disconnect the power plug.
2x.	Drain pump is blocked.
		Clean the drain pump.
(Problems with water
		Remove foreign bodies from
inflow.)
		the pump housing.
	For sink spigot connections:	Clean the sink spigot.
	The sink spigot is blocked.

20