Electrolux LAVAMAT 76820 Connecting the appliance to the water supply, 3

Voltage 240 V AC: Fuse rating 13amps

See rating plate for further information.

This appliance meets VDE requirements.

Particular regulations of local electricity authorities must be observed.

This appliance conforms to EEC Directive No. 82/499/EWG on radio in-

terference.

1WARNING! Repairs to electrical appliances must only be carried out by

trained personnel. Improper repairs may lead to serious risks for the us-

er.

Connecting the appliance to the water supply

Important:

•This appliance must not be connected to the hot water supply.

•When connecting the appliance, use only new hose kits.

•Only connect the appliance to the drinking water supply. Rain water

or water for industrial use may only be used if it fulfils the require-

ments of DIN1986 and DIN1988.

•Do not kink or crush the water inlet hose or drain hose.

The water pressure must be at least 1 bar (=10N/cm2= 0.1MPa), and

may be a maximum of 10bar (=100N/cm2 =1MPa).

–If more than 10 bar: Connect a pressure reductio n valve.

–If less than 1bar: Disconnect the appliance end of the inlet hose from

the solenoid inlet valve and remove the flow meter. (In addition re-

move the filter using pointed pliers and take out the rubber gasket

behind it.) Replace the filter.

A 1.35m long pressure hose is supplied with the appliance.

If a longer inlet hose is required, only hoses from the manufacturer are

to be used. Your local Service Force stocks hose kits of different lengths.

3Sealing rings are either inserted in the plastic nuts of the threaded hose

fitting or are included as spare parts. Do not use any other sealing

rings.