Hood Cleaning
Figure 15
Be sure lights are cool before cleaning the hood.
To Clean Filters
•The metal grease filters will last forever. They are made of anodized aluminum
•It is recommended that the filters be washed at least once a month; they can be washed by hand or in the dishwasher.
•Drain water through edge holes and let each filter dry thoroughly before replacing it.
To Remove The Metal Grease Filters
•Disconnect the hood from electricity.
•Push clips towards the rear and pull the filters downward.
•Disengage each filter from a side and remove it
To Replace The Metal Grease Filters
•Reverse procedure.
To Clean Hood Surface
•For general care, wipe the outside of the stainless steel, white, black or glass hood with sudsy water or household cleaners such as Fantastic® or Formula 409®, rinse well and dry with clean soft cloth to avoid water marks.
•Wipe and dry brushed stainless steel in the same direction as the grain.
•Do not use abrasive products.
•To remove finger prints and give added shine use spray cleaners such as Stainless Steel Magic® and Shimmer®.
Lights replacement | NOTE: Turn blower and lights off. Make sure the lights are cool. If new lights |
Turn off electric power to hood before | do not operate be sure lights are inserted correctly before calling service. |
| |
removing light cover. |
|
Light
Light cover
Figure 16
•Remove the light cover using a little flat screwdriver or similar tool as a lever.
•Remove the damaged light and replace with a new 12 Volt, 20 Watt (maximum) halogen light made for a
•Reinstall the light cover (snap into position).
10
