Electrolux PR 700 manual Electrical Connection, Water Connection, Cooking Accessories, Drainage

4.ELECTRICAL CONNECTION (fig.3)

•The connection to the electrical supply must be carried out according to the standards in force.

•Before carrying out the electrical connection make sure the voltage and frequency on the data plate correspond to those of the supply system.

•A protection onnipolar switch must be installed upstream from the appliance with a suitable capacity and a contact opening distance of at least 3 mm.

•This switch must be installed in the building's main power supply line and near the appliance.

•It is important to connect the appliance to an efficient earth outlet. For this purpose, there is a screw with the symbol Gin the connection terminal board, to which the earth wire is to be connected. The appliance must be included in an unipotential system.

This connection is carried out with a setscrew marked Eplaced under the appliance. The unipotential wire must have a 10 mm2 section.

4.1.ACCESS TO THE MAIN TERMINAL BOARD (fig. 3)

To gain access to the main terminal board first remove the panel below the access door:

• Connect the cable to the terminal board "ma1" following the indications laid down in the wiring diagram attached to the appliance.

5.WATER CONNECTION

The appliance must be supplied with softened drinking water at

0.5to 5 Fh (French hardness) and at a pressure of between 1.5 to 3 bar.

For correct installation, it is also necessary to ensure that:

• The water-inlet pipe "B" (fig.1) is connected to the water mains by means of a cutoff cock with a mechanical filter.

Before connecting the filter run off a certain amount of water in order to remove any eventual ferrous particles from the piping.

5.1.DRAINAGE

•Water must be drained from the appliance using a suitable drainage collector. The steam produced during the drainage cycle must not blow back onto the appliance.

6.COOKING ACCESSORIES

Rectangular basket kit:
Type	1/3	code-number	927214
"	1/2	code-number	927221
Round basket kit (*):
Type	1/3	code-number	927212
Type	1/6	code-number	927213
(*) Used with a lower grill		code-number	927219
Tank lid		code-number	927218

3

The manufacturer declines all responsability if the accident prevention standards are not observed.

9