Problem |
| Possible cause | Solution |
|
| The door has been opened too fre- | Do not keep the door open longer than |
|
| quently. | necessary. |
|
| The product temperature is too high. | Let the product temperature decrease |
|
|
| to room temperature before storage. |
|
| The room temperature is too high. | Decrease the room temperature. |
Water flows on the rear plate |
| During the automatic defrosting proc- | This is correct. |
of the refrigerator. |
| ess, frost defrosts on the rear plate. |
|
Water flows into the refrigera- |
| The water outlet is clogged. | Clean the water outlet. |
tor. |
|
|
|
|
| Products prevent that water flows in- | Make sure that products do not touch |
|
| to the water collector. | the rear plate. |
Water flows on the ground. |
| The melting water outlet does not | Attach the melting water outlet to the |
|
| flow in the evaporative tray above | evaporative tray. |
|
| the compressor. |
|
The temperature in the appli- |
| The temperature regulator is not set | Set a higher temperature. |
ance is too low. |
| correctly. |
|
The temperature in the appli- |
| The temperature regulator is not set | Set a lower temperature. |
ance is too high. |
| correctly. |
|
|
| The door is not closed correctly. | Refer to "Closing the door". |
|
| The product temperature is too high. | Let the product temperature decrease |
|
|
| to room temperature before storage. |
|
| Many products are stored at the | Store less products at the same time. |
|
| same time. |
|
The temperature in the refrig- |
| There is no cold air circulation in the | Make sure that there is cold air circula- |
erator is too high. |
| appliance. | tion in the appliance. |
The temperature in the freez- |
| Products are too near to each other. | Store products so that there is cold air |
er is too high. |
|
| circulation. |
There is too much frost. |
| Food is not wrapped correctly. | Wrap the food correctly. |
|
| The door is not closed correctly. | Refer to "Closing the door". |
|
| The temperature regulator is not set | Set a higher temperature. |
|
| correctly. |
|
Replacing the lamp
1.Disconnect the appliance.
2.Push the movable part to unhook the lamp cover
(1).
3.Remove the lamp cover (2).
4.Replace the lamp with one of the same power and specifically designed for domestic appliances only.
5.Install the lamp cover.
8
6.Connect the appliance.
7.Open the door. Make sure that the lamp comes on.
