Installation
Mounting under a continuous worktop
If installed under a continuous worktop, the appliance is fastened with a mounting screw (A) under the panel.
Rehingeing the door
The side at which the door opens can be changed from the right side (factory adjustment) to the left side, if the installation site requires.
1Warning! When changing the side at which the door opens, the appliance may not be connected to the mains. Remove plug from the mains beforehand.
0Tilt the appliance slightly towards the rear and drop it securely.
0Unscrew the door hinge screws (K)
and take the door bearing (1) downwards out of its cavity.
0 Open the door a little way and take it out downwards.
0Unscrew the upper pin (A) and srew it into place on the opposite side.
0Fit the door into the upper pin (A) and close it.
0Insert the pin of the door bearing
(1) into the left hand cavity and screw the bearing firmly into place with the screws (K).
9
