Installation
Installation Location
The appliance should be set up in a well ventilated, dry room.
Energy use is affected by the ambient temperature. The appliance should therefore
–not be exposed to direct sunlight;
–not be installed next to radiators, cookers or other sources of heat;
–only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed.
The climate classification can be found on the rating plate, which is located at the right on the inside of the appliance.
The following table shows which ambient temperature is correct for each climate classification:
Climate classification |
| for an ambient temperature of |
|
|
|
|
|
|
SN |
| +10 to +32 °C |
|
|
|
|
|
|
N |
| +16 to +32 °C |
|
|
|
|
|
|
ST |
| +18 to +38 °C |
|
|
|
|
|
|
T |
| +18 to +43 °C |
|
|
|
If the refrigeration appliance is installed next to another refrigerator or freezer a clearance of 5 cm at the sides is required, in order to pre- vent the formation of condensation on the outside of the appliance.
Grid preparation
The side at which the door opens can be changed from the right side (as supplied) to the left side, if the instal-
lation site requires.
Warning! When changing the side at A which the door opens, remove plug from
the mains.
Left door opening: | B |
|
☞1. Remove the left side (A) of the grid cutting it from the rear (see figure).
2.Remove the right side (B) of the grid
cutting it from the rear (see figure).
7
