Electrolux SIG 233 Replace the nozzles of the oven burners, Adjustment of minimum level, by-pass

Replace the nozzles of the oven burners

Oven burner

To replace the gas oven nozzle, follow this procedure:

•Check the table no.1 for diameter of nozzle;

•Remove the oven removable base panel;

•Remove the screw 1 on the oven burner

•Remove the oven burner by pulling it forwards.

•Replace the nozzle by means of a No 7 socket spanner;

Reassemble the parts following the same procedure in reverse.

Before fixing of the screw 1, ensure that the oven burner is pushed correctly to the back panel.

Grill burner

To replace the gas grill nozzle, follow this procedure:

•Remove the grill burner after removing the fixing screws.

•Replace the nozzle by means of a No 7 socket spanner;

•Refit all parts and test.

Before fixing of the screws, ensure that the grill burner is pushed correctly to the back panel.

Adjustment of minimum level

Oven burner

•Light the burner knob on position maximum and leave the oven door closed for about 10 min.

•Turn the knob slowly to position minimum.

•Pull off the knob to adjust minimum flow.

•Unscrew or screw the by-pass screw (is it above of tap shaft) until a regular small flame is reached.

•For LPG screw completely the by-pass screw.

The flame shouldn’t extinguish when closing the oven door.

Grill burner

The grill temperature cannot be adjusted. To obtain a lower temperature or slower cooking time the grill pan must be lowered away from the flame.

After completion of any repairs, conversion or adjustments, the statutory safety tests must be carried out.

by-pass

25