|
|
| What to do if ... |
| 45 |
|
|
|
|
|
|
|
|
| |||
|
| Conductance of water at in- | |||
|
| ting for degree of drying (see | |||
|
| stallation site differs from | |||
|
| ‘Programming options’ chap- | |||
|
| standard setting of machine. | |||
|
| ter). |
| ||
|
|
|
| ||
| Loading door does not close. | Filter not in place. | Install filter into place. |
| |
| When a button is pressed, Err | Washing protection. After the | Turn the programme knob to | ||
| start of the programme, the | UIT (off). Set the programme | |||
| appears on the LCD. | ||||
| option can no longer be set. | again. |
| ||
|
|
| |||
|
| Programme selector in UIT (off) | Turn programme selector to | ||
|
| LICHT AAN (light) or to any pro- | |||
| Drum light does not work. | position. | gramme. |
| |
|
|
| |||
|
|
| Replace light bulb (see next | ||
|
| Defective light bulb. | |||
|
| section). |
| ||
|
|
|
| ||
| Displayed programme time | Programme time is corrected |
|
|
|
| automatically depending on | Automatic process; this is not a | |||
| changes erratically or stays un- | ||||
| type and volume of laundry | machine fault. |
| ||
| changed for a long time. | and level of dampness. |
|
|
|
|
|
|
|
| |
|
| Not enough washing loaded or | Select time programme or |
| |
| Drying cycle ends shortly after | higher drying level (e.g. EXTRA | |||
| programme starts. | washing loaded is too dry for | DROOG (extra dry) instead of | ||
| selected programme. | ||||
|
| KASTDROOG (stroage dry)). | |||
|
|
| |||
|
| Filter clogged. | Clean filter. |
| |
|
| Load volume too big. | Reduce load volume. |
| |
| Drying cycle lasts an unusually | Laundry insufficiently spun. | Laundry must be adequately | ||
| long time. Note: After around 5 | spun. |
| ||
| hours the drying cycle ends au- |
|
|
|
|
| Particularly high room temper- | Automatic process, there is no | |||
| tomatically. | ||||
|
| ature. Temporary switching off | fault with the appliance. If pos- | ||
|
| of the compressor to avoid | sible, lower the room tempera- | ||
|
| overload. | ture. |
| |
|
|
|
|
|
|
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can be obtained from your local service centre.
When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open.
WARNING!
Do not use standard bulbs! These develop too much heat and may damage the machine! Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully unscrew or deactivate the fuse.
1.Unscrew cover above the bulb (this can be found directly behind the loading aperture, at the top; refer to “Description of machine” section.)
2.Replace defective bulb.
3.Screw cover back down.
