Maintenance and cleaning
The filters
For your tumble dryer to function correctly, the filters need to be cleaned before or after every load dried.
To clean them:
1. Open the door.
2.Open the coarse filter upwards (Fig. A).
3.Brush the fluff off the fluff filter, which is under the coarse filter (Fig. B). Sometimes you may need to remove the fluff filter to clean it on both sides.
Make sure that you put the fluff filter back correctly after cleaning, before closing the coarse filter.
Never start the dryer unless the fluff filter is clean and correctly in place, or if the fluff filter is damaged (this could cause overheating).
The condenser
As in all types of tumble dryer, the air circulated through the dryer picks up fluff. As a result, some fluff will accumulate in the condenser, so it needs to be cleaned occasionally.
To clean the condenser:
1. Open the door and open the coarse filter upwards.
2.Remove the fluff filter and close the coarse filter again.
3.Grasp the recesses at the top of the condenser with your fingers and use your thumbs to press against the door (Fig. C & D).
The condenser will come free, allowing you to lift it outwards/upwards. Be careful not to damage the sensitive aluminium section.
4.Turn it upside down and clean it on both sides, using a vacuum cleaner. Remove the red drain plug on the lower edge of the condenser (Fig E). Lay the condenser flat and fill it with water through the filter opening. Now leave the condenser to soak in water for about 5 minutes, then shower both sides with hot water. (Fig. F).
Dry the condenser carefully afterwards. Don’t forget to put back the red drain plug (Fig. G).
5.Put the condenser back in the dryer. Make sure that its base is lined up in the slots in the condenser cavity inside the dryer door.
Press the condenser carefully into place until you feel and hear a gentle “snap”. Put back the fluff filter and close the coarse filter.
A
B
C
D
E
F
G
- 8 -
