Electrolux U29065 user manual Something not working

Something not working

IMPORTANT!

Before contacting your local Service Force Centre check the following points.

IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.

Fault code / malfunction Solution

The appliance works, but the pilot Please contact the nearest service centre. light is flashing

No power to appliance	Check there is power at the socket.
	Check there is not a power cut by checking the household lights.
	Check the fuse has not blown.
The temperature in the freezer is
	Check the thermostat control knob is turned to the
too high	correct setting relative to ambient conditions.
	Check the ambient temperature is within the appliances
	operating limits of 10°C to 32°C.
The freezer door will not open	Has door just been opened?
	If so leave for a few minutes to allow the air pressure to
	equalise.
The compressor runs
	Adjust the thermostat control knob to give correct
continuously	temperature control. See page 5.
	Check that the door is closed.
	Large quantities of food have recently been placed in
	the cabinet and/or door is frequently opened.
	Check that air ventilation is not obstructed.
Excessive frost and ice has built	Ensure the door is not left open.
up.	Check that nothing is preventing the door from closing. Is the
	door gasket intact and clean?
	Has advised periodic defrosting been carried out?
Noise
	Refer to normal operating sounds.

If after the above checks, there is still a fault, call your local Service Force Centre.

In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

Please note that proof of purchase is required for any in-guarantee service calls.

IMPORTANT!

When carrying out the suggested corrective actions the appliance must be switched off.

12