Maintenance and Cleaning, Internal Cleaning | Electrolux U31462

Maintenance and Cleaning

Before any maintenance or cleaning work is carried out DISCONNECT the appliance from the ELECTRICITY supply.

Internal Cleaning

01. Clean the inside and accessories with warm water and bicarbonate of soda (5 ml to 0.5 litre of water). Rinse and dry thoroughly.

1Warning!

•Do not use detergents, abrasive powders, highly perfumed cleaning products, wax polishes or cleaning products containing bleach or alcohol.

2.Regularly check the door seals and wipe clean to ensure they are clean and free from debris.

External Cleaning

1 Warning!

•Do not use abrasive products

•There are sharp edges on the underside of the product so care should be taken when cleaning.

1Important: Do not use cleaning agents for stainless steel or other aggressive or abrasive cleaning agents. The protective coat of lacquer on the stainless steel surface can be damaged by these.

The coat of lacquer protects against finger prints and therefore additional cleaning agents and maintenance products are no longer required.

01. Wash the outer cabinet with warm soapy water.

2.After cleaning wipe with fresh water and rub dry.

2 Accumulation of dust at the condenser increases energy consumption. For this reason carefully clean the condenser at the back of the appli- ance once a year with a soft brush or a vacuum cleaner.

818 35 94-01/2

29

Image 29

Electrolux U31462 operating instructions Maintenance and Cleaning, Internal Cleaning, External Cleaning

Contents

Arctis Dear customer Contents What to do if Cooling drinks Prior to Installation Important Safety InstructionsInstallation Refrigerant Maintenance and Cleaning Child SafetyDuring Use Servicing Appliance Transport Environmental InformationPackaging material Old appliance Fitting the Door Handle Before UsePackaging Dle bracket on the lower left-hand side of the door Installation Location InstallationA higher power consumption see also Something not working Freezer needs ventilation Electrical Connection Appliance AlignmentEarth Nals in your plug, proceed as fol- lows Right. Close the door Reversing the door Move the upper hinge bracket pivot to the left Reversing the door No-frost frost free system Cold accumulation block Description of the applianceView of the appliance Control Panel Temperature setting buttonsThese buttons are connected to the temperature display Temperature display TURBO/FROSTMATIC-button Alarm OFF button Remove the cold accumulation block from the appliance Prior to Initial Start-UpInitial use Select Freezing or Cooling Temperature Adjustment Switching the Appliance Off Red warning indicator will go out when the door is closed Temperature WarningControl and Information Systems Open Door Warning Opening the door Temperature memoryFunction Errors Freezing Only in the operating mode Freezing Tips Frozen StoragePreparation of Ice Cubes Maximum Load Storage Goods Symbols/Freezing CalendarCooling Long Fresh Cooling Cooling drinks Standard Cooling Hints and Tips Energy Saving AdviceNormal Operating Sounds Food Storage External Cleaning Maintenance and CleaningInternal Cleaning Correcting Malfunctions What to do if What to do if Replacing the light bulb Regulations, Standards, GuidelinesReplace defective light bulb Place the cover again Refrigerant circuit has been checked for leaks Refrigerant Circuit Technical TerminologyEvaporator Compressor Standard Guarantee Conditions Guarantee Conditions 08705 929 Service & Spare PartsCustomer Care Major Appliances Subject to change without notice