Electrolux U3701, U3702 | INSTRUCTIONS FOR USE | MAINTENANCE, In case of using a cloth bag, SPARES, CLEANING THE MOTOR FILTER, Replacement Motor filter Part No F9001. (Menalux)

INSTRUCTIONS FOR USE MAINTENANCE

In case of using a cloth bag

a.Follow the steps 1 and 2 on page 4.

b.To open the bag, remove the plastic clip by sliding it off the bag.

c.Empty the bag, realign the bag folds, bag seal and slide on the plastic clip.

d.Refit the bag in the holder, ensuring it is seated in position and close the dust compartment cover until it is locked.

Note: The cloth bag may be washed in lukewarm water and dried completely. It should not be washed in washing machine.

Note: Replace the paper dust bag even if it is not full (the pores may be blocked). It is also recommended to replace the bag after using cleaning powder. Use only genuine replacement bags. Dust Bag Part No T196F/1002 (Menalux).

WARNING: On collection of Proprietary carpet conditioning powders, plaster / concrete dust, it is recommended that the dust bag is changed. Some of the preparations contain substances which if left in the vacuum cleaner for extended periods. could create damage. Many air fresheners, household deodorants, sprays and polishes contain highly inflammable gas propellants. Because of this it is particularly important that these products are used strictly in accordance with the relevant manufacturers instructions It is essential that none of the above products are sprayed directly into the vacuum cleaner or any of the filters, hose assembly or dust chamber.

SPARES

New filters and dust bags can be obtained from your Authorised Volta service provider, please refer to the Electrolux Floor Care and Small Appliances Website, www.electrolux.com.au or contactour customer service on 1300 366 366.

CLEANING THE MOTOR FILTER.

It is recommended that the motor filter should be cleaned approximately every three months or when it is visibly soiled.

1.Open the dust bag compartment cover and remove the dust bag from the holder. Lift out the motor protection filter and holder from the locating position in the rear wall. Inspect the filter, if heavily soiled replace it, lightly soiled, wash and leave to dry completely before installing it back into the cleaner.

2.On fitting the filter complete with holder, ensure it is seated in position correctly and the bag is seated in the bag holder, before closing the dust

compartment lid.

Replacement Motor filter Part No F9001. (Menalux)

5