34Care and cleaning
8. Put the cap back on the emergency emptying hose and place the latter back in its seat.
9.Screw the pump fully in.
10. Close the pump door.
Warning!
When the appliance is in use and depending on the programme selected there can be hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the cover, ensure it is securely retightened so as to stop leaks and young children being able to remove it.
Water inlet filter
If you notice that the machine is taking longer to fill, check that the filter in the water inlet hose is not blocked.
1.Turn off the water tap.
2.Unscrew the hose from the tap.
3. Clean the filter in the hose with a stiff brush.
4. Screw the hose back onto the tap.
Frost precautions
If the machine is installed in a place where the temperature could drop below 0°C, proceed as follows:
1.Close the water tap and unscrew the water inlet hose from the tap.
2.Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out.
3.Screw the water inlet hose back on and reposition the emergency emptying hose after having put the cap on again.
By doing this, any water remaining in the machine is removed, avoiding ice forming and consequently damage to the appliance.
When you use the machine again, make sure that the ambient temperature is above 0°C.
