Electrolux 9CHG584139 INSTALLATION INSTRUCTIONS 6.WATER CONNECTIONS, 6.1DRINKING WATER CONNECTION

INSTALLATION INSTRUCTIONS

6.WATER CONNECTIONS

6.1DRINKING WATER CONNECTION

•Before connecting the appliance, flush the water pipes and fittings and clean out any dirt.

•The appliance is designed for connection to fixed lines.

•Metal installation pipes may not protrude more than 3.9“ (10 cm) from the floor or the wall.

•The maximum water pipe pressure must not exceed 87 psi (600 kPa).

•A mechanical filter, a shutoff valve and a non-return valve should be built into the customer fresh water feed pipe.

•In general, all national and local water regulations must be observed.

•The appliance is to be connected to the sanitation system in accordance with the valid installation connection plans and diagrams.

6.1.1FREE-STANDING INSTALLATION The water connections come up from the floor.

DMake corresponding openings in the base of the frame to lead the hoses through.

DRemove front panel (B) (see Chapter 3. on page 7).

DDismantle the storage space or hot cabinet if necessary.

DConnect the flexible hoses (5), with a G ½" inside thread, with or without fitting a stop valve, to the customer-supplied water pipes protruding from the floor.

6.1.2FITTING AGAINST A WALL

The water connections come up from the floor or out of the wall. For floor connection (see Chapter 6.1.1 on page 9).

DPull the flexible hoses (5) out of the open rear wall and con- nect to the customer-provided water pipes protruding from the wall with a G ½" inside thread, with or without fitting a stop valve.

DPosition the appliance against the wall.

6.2WASTE WATER

The appliance outlet pipe must be taken through a sufficiently large waste water opening.

Note

Ensure accurate measurement of the waste water collecting point and the exact positioning of the appliance.

62.9680.01_UL Page 9