ENGLISH
15
system save up to 30% in time over traditional models.
If the hood is opened during this stage the message
"CLOSE" will scroll on the display:
The filling and heating stage has finished when the
display shows the tank temperature:
To display the boiler temperature during heating of the
tank, open the hood and press “J” button (Figure 13).
D2 WASH CYCLES
The wash cycle includes one wash with hot water and
detergent (150°F/66°C min.) and one rinse with hot
water and rinse-aid (180°F/82°C min.).
Table of times
Standard cycle time with supply water at 122°F/50°C.
A device lengthens the cycle time if the water in the boi-
ler has not reached the minimum temperature for correct
rinsing.
The cycle times and the temperature may be personali-
sed (e.g. increase of the rinse time and temperature).
The cycle times should only be set by an Authorized
Service technician.
D3 OPERATION
The filling and heating stage has finished when the dis-
play shows the tank temperature:
The appliance is then ready for use:
Raise the hood.
Pour the required amount of detergent into the tank
(in models without automatic dispenser).
Insert the rack containing the dirty dishes.
Close the hood and select the suitable wash cycle; the
corresponding indicator light comes on and the wash
cycle starts:
- Cycle I
For lightly soiled dishes: press “J” button (Figure 13)
(see table of times).
- Cycle II (recommended)
For normally dirty dishes: press “H” button (Figure 13)
(see table of times).
- Cycle III
For very dirty dishes: press “F” button (Figure 13)
(see table of times).
- Cycle IV
For particularly dirty dishes with dried food residue,
dishes with a special shape or for other specific needs of
the user: press “G” button (Figure 13), which initiates a
continuous wash until the operator selects an automatic
cycle.
To stop the wash cycle, just press the selected cycle
button or open the hood.
To continue the wash cycle, just press the selected
cycle button or close the hood. The cycle starts again
from where it stopped.
At the end of the wash, the dishwasher emits a series
of beeps and “END” blinks on the display:
lift the hood and remove the rack containing the clean
dishes.
WARNING
The appliance will not remove burnt food deposits from dishes. Dishes with burnt-on food deposits should be cleaned manually using detergent before putting them in the dish-washer.
Change the water in the tank at least twice a day.
I II III IV
WT65H 60 sec. 70 sec. 120 sec. INFINITE
1
1
2
3