Electrolux Z4700 Series manual Periodic Maintenance, Brushroll Belt, To Change Belt

PERIODIC Maintenance

CAUTION: Turn off the switch and unplug the electrical cord before replacing belt. Motor shaft can become hot during normal use. To prevent injury, avoid touching the motor shaft when checking the belt. (FIG. 20 )

	Brushroll
PERIODIC
	The brushroll turns as it sweeps and combs the carpet nap. Remove
	hair and threads from the brushroll so it continues brushing the
	carpet. To maintain the most efficient cleaning, the bristles must
	touch the carpet. To test the bristle length, hold a ruler against the
MAINTENANCE	underneath side of the cleaner. If the bristles no longer touch the
	ruler, replace the brushroll.
	Brushroll Belt
	Brushroll Performance Window (FIG. 19). To check condition
	of the belt watch to see if white dots on the belt are moving
	through the performance window (FIG. 19a). This indicates
	the brushroll is turning.
	The brushroll belt turns the brushroll to agitate, sweep, and comb
	the carpet nap. Check the belt regularly to be sure it is in good
	condition. Replace the belt if it stretches, cracks or loses tension.
	Cut away any hair or threads wound around the brushroll or the
	belt pulley because the buildup could cause the belt to rotate
	unevenly.
	NOTE: Care should be taken when vacuuming rugs to
	ensure that edges and fringes do not snap the
	drive belt and stop the rotation of the brush roll.

19a

FIG. 19

To Change Belt

Step 1:	Lower handle to floor to change belt.
Step 2:	Remove two screws to release hood (FIG. 19).
	Lift hood to expose belt and brushroll (FIG. 20).
Step 3:	Lift right side of brushroll and pull out of base.

Brushroll	Step 4:	Remove and discard belt.
	Step 5:	Clean debris from brushroll area. Clean any
		burnt rubber from motor shaft using fine
		sandpaper or an emery board.
	Step 6:	Place new belt around motor shaft.
Brushroll	Step 7:	Place belt around right side of brushroll.
	Step 8:	Pull right side of brushroll to stretch belt. Secure
		right end cap into base.
	Step 9:	Align left end cap with square in base. Push end cap
Belt		into place.
	Step 10: Rotate brushroll to position belt on brushroll pulley.
	Step 11: Replace the hood.
	Step 12: Tighten screws.
	NOTE: Use only GENUINE ELECTROLUX
12		replacement brushroll belt, Code ZE090.

Motor

Shaft

FIG. 20

PLEASE NOTE: The new belt will be smaller in diameter compared with the used belt. Therefore, it will require stretching into place. This is normal.