Electrolux Z9120 manual How to Use, Handle Adjustment, Power Switch, Cleaner Height Settings

How to Use
2.
	Carpet
	Bare Floors
1.
Recommended
Settings	Example of Carpet

Position 1	Hard Floors
Position 2	Low Pile
Position 3	Medium Pile
Position 4	High Pile

3. 5.

4.

6.

7.

8.

9.

10.

The upright vacuum cleaner is designed to be used on multiple types of carpeting. Do not attempt to use the upright cleaner with the brush roll operating on bare floors, as damage to the floor covering may result.

HANDLE ADJUSTMENT

1.With the tip of the foot press down on the left portion of the handle release located at the left rear side of the cleaner. Move the handle and adjust it to the desired position. The unit can lay completely flat for cleaning under low furniture.

POWER SWITCH

2.The power switch is mounted on the top of the filer assembly on the left side of the cleaner. The power is off with the switch in the center position. Press the front of the switch for cleaning carpet, press on the rear of the switch to clean bare floors.

CLEANER HEIGHT SETTINGS

3.The front of the cleaner has an adjustment that raises or lowers the cleaner base to match the type of carpet. With the power cord unplugged, set the adjustment to the

lowest setting for maximum cleaning. If during use, the cleaner is difficult to push, move the adjustment to the next height setting until the cleaner is comfortable to push. The brush roll must reach the carpet for effective cleaning.

Attachment Cleaning

4.For those models equipped with this option, the cleaner easily converts to attachment cleaning. The cleaner should be locked in the upright position. Remove the wand assembly and rotate the suction control valve towards the back of the cleaner to the hose position.

5.The valve should be in a horizontal position with the indicator pointing to the Hose setting.

6.To return to floor cleaning, rotate the valve towards the front of the cleaner until the indicator points to the Floor setting. Replace the wand into the lower retainer and secure into the wand clip. The cleaner is equipped with a wand device that prevents the wand from being stored until the suction control valve is set to the floor position.

7.To extend the cleaning reach of the wand, push the dark gray button nearest the handle and pull down on the outer wand section.

Reverse the process before returning the wand to the storage position.

8.The wand assembly has a built-in crevice tool and a permanently attached dusting brush. To engage the dusting brush press the dark grey button and slide the brush over the crevice tool until it locks. Reverse the process for storage.

Changing the dust bag

(Bag Code E87)

9.Pull up on the dust bag cover latch release and fully open the cover to expose the bag

10.Pull the dust bag straight up to remove. Insert new bag and close the cover making sure the latch locks into the handle. Note: the dust bag cover will not latch without a dust bag installed.