Error Messages
|
| Error: 7 |
|
| Check |
Normal. Timer: Auto | Normal. Timer: Auto | the bumper |
Select start time? | Select start time? | See manual |
To program the cleaning time:
1. | Start Trilobite. |
2. | Press until “Select start time” is displayed. |
3.Press .
4.“Timetab.” is displayed. (If the clock is not set, “Set time” is displayed. See above on setting the time.)
5.Press 
.
6.“Select start day” is displayed.
7. Press until the desired day is displayed.
8.Press .
9.“Select start time” is displayed.
10. Press until the desired hour is displayed.
11.Press .
12.Press 
until the desired minute is displayed.
13.Press 
. The desired start time and pro- gram are displayed. The default setting is the normal program with automatic timer.
14.“OK?” flashes. If the setting is correct, confirm with 
. “Start cleaning?”
is displayed. Proceed to step 22.
If you require a different cleaning program:
15. | Press | . “Select program?” flashes. |
16. | Press . | |
17. | Press | to select the desired program. |
18.Press .
19.Select the desired cleaning time. (See “Timer” on this page.)
20.The set program is displayed. “OK?” flashes. Confirm with 
. “Start cleaning?” is displayed.
21.Repeat the programming steps for any other days you want cleaning to be out.
22.Press “On/Off” button and place it in the charger.
When Trilobite is placed in the charger and a cleaning program is active, a clock symbol is displayed. (Trilobite will now clean on the set time.) NOTE: If batteries are not fully charged at set start time, the cleaning start will be skipped or delayed up to one hour.
To activate Trilobite:
1. | Start Trilobite. | |
2. | Press | until “Select start time” is displayed. |
3. | Press . | |
4. | Press | to select “Enable”. |
5. | Press | to activate the cleaning program. |
To deactivate Trilobite:
1. | Start Trilobite. | |
2. | Press | until “Select start time” is displayed. |
3. | Press . | |
4. | Press | to select “Disable”. |
5. | Press | to deactivate the cleaning program. |
To remove a cleaning program:
1. | Start Trilobite. |
2. | Press until “Select start time” is displayed. |
3.Press .
4.Select “Timetab.”.
5.Press 
.
6.“Select start day” is displayed.
7.Press 
until the day is displayed on which you wish to remove the cleaning program.
On days with cleaning set, the start time is displayed; otherwise
8.Press 
“Select start time” is displayed.
9. Press until
10. Press .
Error Messages
The only faults that you can rectify yourself are the ones listed below. In the event of other error messages, recharge and restart your Trilobite. If it still does not start, contact our Customer Service, see page 18.
The errors you can correct yourself are presented below:
5.Check roller.
Is something stuck?
Is it incorrectly attached?
6.Check casters.
Is something stuck?
7.Check bumper.
Verify its spring action. Is something stuck preventing it from moving?
12.Trilobite is stuck.
Move it and switch it on again.
Also see Normal Vacuuming on page 5.
15.Check dust cassette.
In most cases, the filter unit has probably not been set or it is incorrectly set.
16.Check charger.
Is the charger connected to the mains?
Are the terminals on the charger and Trilobite properly connected to each other?
21.Moisture on the circuit board.
Let the machine dry out for 12 hours. Then try restarting it.
English 13
