20
Fitting the Hob into the Worktop
Carry out the building in of the hob as
follows:
• place the seals supplied with the
hob on the front edge of the cut
out. Then, place them at 86 mm
from the side edges and at 10 mm
from the rear edge, as shown in
the diagram, taking care that the
seals meet without overlapping.
• place the hob in the cut out,
taking care that it is centred;
• fix the hob with the relevant fixing
clamps and screws, as shown in
the diagram. When the screws
have been tightened, the excess
seal can be removed.
The edge of the hob forms a double seal
which prevents the ingress of liquids. Seal