8
Lighting the burnersLighting the burners
Lighting the burnersLighting the burners
Lighting the burners
For easier lighting, proceed before puttingFor easier lighting, proceed before putting
For easier lighting, proceed before puttingFor easier lighting, proceed before putting
For easier lighting, proceed before putting
a pan on the pan support.a pan on the pan support.
a pan on the pan support.a pan on the pan support.
a pan on the pan support.
To light a burner:
zturn the relevant knob anti-clockwise to maximum
position ( ), then push it down to ignite the
burner.
zUpon ignition, keep the knob pushed down
about 5 seconds 5 seconds
5 seconds 5 seconds
5 seconds. This will allow the
"thermocouple" (see diagram - letter D) to be
heated and the safety device to be switched
off, otherwise the gas supply would be
interrupted.
zThen adjust the flame as required.
If the burner does not ignite, turn the control knob
to zero, and try again.
If you cannot light the flame even after
severalattempts, check the "cap" (see diagram
- letter AA
AA
A) and the"crown" (see diagram - letter
BB
BB
B) are in the correct position.
)OperationOperation
OperationOperation
Operation
Hob burners control knobsHob burners control knobs
Hob burners control knobsHob burners control knobs
Hob burners control knobs
The symbols on the knobs mean that :
there is no gas supply
there is maximum gas supply
there is minimum gas supply
AA
AA
A - Burner cap
BB
BB
B - Burner crown
CC
CC
C - Ignition electrode
DD
DD
D - Thermocouple
A
B
C
Triple crown burner