Elmo instruction manual Camera Controls, TSE270X, TSE272X, TSE271X

CAMERA CONTROLS

By adjusting the switches/potentiometers provided on the side panel, the control functions are available.

1AES switch

[Electronic shutter] The camera is factory-set at the AES switch OFF and 1/60 sec. shutter speed.

[AES (Automatic Electronic Shutter)] By setting the AES switch to ON, the Automatic Electronic Shutter mode (1/60~1/100,000 sec) is available.

Note: In electronic shutter mode; *Sufficient brightness is

required.

*The picture will flicker when shooting under the illumination produced by fluorescent lamp.

TSE270X, TSE272X

SENS-UP				AUTO IRIS	V-PHASE
AES		BLC	ALC	DC VIDEO
ON			LEVEL
OFF
1	2	3	4	5	6

2SENS-UP switch

To increase the sensitivity, set this switch to ON position.

3BLC (Back Light Control) switch

In case the back oighting is too brighit to shoot the main object clearly, set this swith to ON position.

4ALC LEVEL

Adjust video output level, when AUTO IRIS switch is DC position.

TSE271X

SENS-UP				AUTO IRIS
AES		BLC	ALC	DC VIDEO
ON			LEVEL
OFF
1	2	3	4	5

5AUTO IRIS switch

When a DC driven type auto iris lens is used, set this switch to DC position.

When a video feedback type auto iris lens is used, set this switch to VIDEO position.

6Vertical sync. phase adjustment potentiometer

Vertical sync. phase adjusting potentiometer is set at the position fully counterclockwise that the delay time of vertical sync. phase against the phase of power frequency is shortest, when shipped from the factory.

Turning this potentiometer clockwise will make the delay time of vertical sync. Phase against the phase of power frequency longer.

Use the function control potentiometer 6 if the picture image on a monitor TV may flow when using the camera in combination with other camera(s) controlled by the Line-Lock synchronization.

In this case, get a proper image by shifting the phase of vertical sync. signal of the camera against that of the other. If a proper image cannot be obtained even after this adjustment, reset the potentiometer to its original position, and use the function control potentiometer 6 of the other camera to shift the phase of vertical sync. signal of other camera.

Caution: Before making adjustment, make sure that cameras have their power supplies connected with the same polarity. (not 180°apart)

- 6 -