GETTING STARTED
Getting started
1.Connect the amplifier to the mains. Always connect the mains to an earthed outlet with a 3 pole CE approved mains cord.
2.Make sure that there’s a speaker cabinet connected to the appropriate jack socket, regarding impedance, on the back of the amplifier.
3.Make sure that you are using a correct speaker cable for the speaker outputs. Low signal cables, such as regular guitar cables, might seriously damage the output stage of the amplifier.
Note: Never operate the amplifier without a connected speaker since this can cause severe damage to the amplifier.
4.Connect the accompanying foot switch to the jack sockets marked 1 and 2 respectively.
5.Set the switch marked "Power" to position ON.
6.Check that Master 1 and Master 2 volumes are set fully counter clock wise.
7.Allow the amplifier to build up heater and bias voltages for approximately 30 seconds before switching on the Standby switch.
The amplifier is now ready for use.
Plug in your guitar in the Input jack socket.
Getting some sound
•Adjust all the knobs except the Master volumes, on the front of the amplifier to 12 o’clock.
•Set the toggle switches at the front of the amplifier to position OFF and Channel 1 respectively.
•Press the Master 1 switch on the foot switch so the led will light up and slowly turn up Master 1 on the amplifier.
You should now be able to hear some sound coming out the speaker(s).
M90 Modena – Owner’s Manual – Ver: 2.21 | 6 | Elmwood Amps |
