CHANNEL 1
Channel 1
•Press the Channel switch on the foot switch so that the led will go dark to activate Channel 1.
By adjusting Volume, Treble, Mid and Bass you can change the sound and vary from clean to distortion. The EQ section is very effective and you will not have any problem finding your favourite sounds.
For cleaner sounds it’s recommended to keep the channel 1’s volume below 12 o’clock (some low output single coil equipped guitars might stay clean beyond 12 o’clock while a hum bucker equipped guitar needs lower settings for clean sounds) and adjust the overall output with the master volume(s).
•Press the Boost/Drive switch on the foot switch so that the led will light up. You have now activated the Drive mode.
•Still on Channel 1 - slowly turn up Drive Ch1 and Drive Ch1 Volume.
The Drive Ch1 knob decides the amount of distortion and the Drive Ch1 Volume knob controls the volume in drive mode.
The EQ section and the Volume on Channel1 are still active also when Drive is activated. By adjusting Drive Ch1 and Volume differently there are a wide range of different sounds to achieve - from lightly
•To turn off the Drive mode; simply press the Boost/Drive switch again.
M90 Modena – Owner’s Manual – Ver: 2.21 | 7 | Elmwood Amps |
