Elo TouchSystems ET1X8XC-4XWA-1, ET2187C-4XWA-1 manual Connect the Power Cable

Connect the Power Cable

Connections on underside

Power cable

Power cable

•Your monitor does not include a power cable. You may either purchase a country specific power cable from Elo (www.elogaming.com), or construct your own custom power cable (see Appendix B for details). Connect the power cable to the AC connector on your touchmonitor. To protect your equipment against risk of damage from electrical surges in the power line, plug the touchmonitor’s power cord into a switched surge protector, and then connect the surge protector to a grounded (three-pronged) AC electrical outlet.

•Your touchmonitor has no power switch. Power on your monitor using the power switch of the surge protector, and check that the power LED is on. If not, refer to Chapter 4, Troubleshooting.

•After a brief pause the picture should appear. If necessary, adjust the front panel controls according to your personal preference (see Chapter 3).

•Insert the Elo TouchTools CD-ROM in your computer’s CD-ROM drive to install the appropriate touchscreen driver software. Follow the directions starting on the next page to install the driver software.

NOTE: If this monitor is intended to be used in an existing system, the driver software may already be installed by the system manufacturer. Skip to Chapter 3.

2-6E l o E n t u i t i v e T o u c h m o n i t o r U s e r G u i d e