Notes
Important BIOS Reset / No picture information
Please note that when performing a “Load Optimized Defaults” or “Load
However, by using the standard RGB OUT DSUB connector connected to an external TFT Display or CRT Monitor, you will get a cloned picture from the MMC unit. Now you can correctly setup the display properties in the BIOS, which will
If you have no external display or monitor available, you can use the “blind man” routine:
1:Power on the MMC unit, while pressing <DEL> on the keyboard to enter BIOS setup.
2:Press the <DOWN ARROW> key 2 times, then press <ENTER>
3:Press the <DOWN ARROW> key 17 times, then press <ENTER>
4:Press the <DOWN ARROW> key 5 times (15 inch), 3 times (19/20 inch) or 6 times (23 inch) followed by pressing <ENTER>
5:Press <F10> on the keyboard, and press <ENTER>. The BIOS settings will be saved, and the unit will reset and boot up correctly with picture on the MMC Unit again.
BIOS Setup Menu Reference:
All versions of 15 Inch - JH
-Choose “Advanced Chipset Features”
-Choose “Panel Number”
- Choose “1024x768 24bit SC”
All versions of 19 Inch - JH
-Choose “Advanced Chipset Features”
-Choose “Panel Number”
- Choose “1280x1024 24bit SC”
All versions of 20 Inch - JH
-Choose “Advanced Chipset Features”
-Choose “Panel Number”
- Choose “1280x1024 24bit SC”
All versions of 23 Inch - JH
-Choose “Advanced Chipset Features”
-Choose “Panel Number”
- Choose “1600x1200 24bit SC”
When done, please refer to the BIOS manual if you need to change other options (available on separate/attached CD for your specific product).
Appendix | 52 |