Eltax AVR-800 owner manual Important Safety Instructions

FOREWORD

This section must be read before any connection is made to the mains supply.

WARNINGS

Do not expose the equipment to rain or moisture. Do not remove the cover from the equipment.

Do not push anything inside the equipment through the ventilation holes.

Do not handle the mains lead with wet hands.

EQUI PMENT MAI NS WORKI NG SETTI NG

Your ELTAX product has been prepared to comply wit h t he household power and safet y requirements that exist in your area.

AVR-800 can be powered by 230 V AC only.

I MPORTANT:( FOR UK VERSI ON)

This apparatus is fitted with an approved moulded 13 Amp plug.

To change a fuse in this type of plug proceed as follows:

1.Remove fuse cover and fuse.

2.Fix new fuse which should be a BS1362 13A,A.S.T.A or BSI approved type.

3.Refit the fuse cover.

I f the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place.

If the mains plug contains a fuse. this should have a value of 13A.

I f a plug without a fuse is used. the fuse at the distribution board should not be greater than 5A.

Note:

The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13A socket elsewhere.

HOW TO CONNECT A PLUG

The wires in t he mains lead are coloured in accordance with the following code. BLUE-"NEUTRAL"("N")

BROWN-"LIVE"("L")

1.The BLUE wire must be connected to the terminal which is marked with the letter "N" or coloured

BLACK.

2.The BROWN wire must be connect ed t o t he terminal which is marked with the letter "L" or colourde, RED.

3.Do not connect either wires to the earth terminal in the plug which is marked by the letter "E" or by the safety earth symbol or coloured green-and-yellow.

Before replacing the plug cover. make certain that the cord grip is clamped over the sheath of the lead-not simply over the two wires.

COPYRIGHT

Recording and playback of any material may require consent. For further information refer to the following: -Copyright Act 1956

-Dramatic and Musical Performers Act 1958 -Performers Protection Acts 1963 and 1972

-any subsequent statutory enactments and orders.

IMPORTANT SAFETY INSTRUCTIONS

ABOUT THI S USER GUI DE

Refer to the figures on page 2 of this user guide. All references to the controls that are printed in BOLD type are as they appear on the unit.

PRECAUTIONS

The following precautions should be taken when operating the equipment.

GENERAL PRECAUTI ONS

When siting the equipment ensure that: -The ventilation holes are not covered;

-Air is allowed to circulate freely around the euipment -It is on a vibration free-surface;

-It will not be exposed to interference from an external source;

-I t will not be exposed t o excessive heat , cold, moisture or dust;

-It will not be exposed to direct sunlight;

-It will not be exposed to electrostatic discharges Never place heavy objects on the equipment.

If a foreign body or water does enter the equipment, contact your nearest dealer or service centre.

Do not pull out the plug by pulling on the mains lead, hold the plug.

It is advisable when leaving the house, or during a thunderstorm. to disconnect the equipment from the mains supply.

The equipment draws nominal nonoperating power from the AC outlet with its POWER switch in the STANDBY position.