![](/images/new-backgrounds/1035161/351619x1.webp)
Read this before operation
Read this before operation
<Choose the installation location of your unit carefully. Avoid placing it in direct sunlight or close to a source of heat . Also avoid locations subject to vibrations and excessive dust, heat, cold or moisture.
<The ventilation holes should not be covered. Make sure there is enough space above and beside t he amplifier/ receiver (about 4 inches). Do not place a CD player or other equipment on top of the amplifier/receiver.
<Do not open the cabinet as this might result in damage to the circuitry or electrical shock. If a foreign object should get into the set, contact your dealer.
<When removing the power plug from the wall outlet, always pull directly on the plug, never yank the cord.
<Do not attempt to clean the unit with chemical solvents as this might damage the finish. Use a clean, dry cloth.
<Keep this manual in a safe place for future reference.
Back-up Memory Function
This is the function which preserves the preset memory and
If the power supply is interrupted for 3 days or longer, the memory settings will be erased.
When to Use RESET Switch
<When this system is subjected to an electrical shock.
<When the power is irregular.
In these cases, try the following
Press the TUNING MODE button for more than 5 seconds.
Note:
If the TUNING MODE button is pressed for more than 5 seconds Standby mode, all the memory will be erased.
Before Use
Before Connection
CAUTION
Turn off the power of all the equipment before making connections.
Read instructions of each component you intend to use with this unit.
<Be sure to insert each plug securely. To prevent hum and noise, do not bundle the connection cords with the power cord or speaker cord.
Speaker Connections
Caution:
To avoid damaging the speakers with a sudden
< Check the impedance of your speakers.
Connect speaker with an impedance of 8 ohms or more. The amplifier's red speaker t erminals are t he + (positive) terminals and the black terminals are the _ (negative) terminals.
<The + side of the speaker cable is marked to make it distinguishable from the _ side of the cable. Connect
this marked side to the red + terminal and the unmarked side to the black terminal.
<Prepare the speaker cords for connection by stripping off approximately 10 mm or less (no more as this could cause a
Twist the wires tightly together so that they are not straggly :
How to connect
Press the lever, insert the stripped and twisted end (approx. 3/8") of the cord, then release the lever : Make sure it is fastened securely by pulling the cord lightly.