Product Information Sheet |
Figure 3 – Sensor and Input Board Wiring
Finishing the Installation
Once the back plate of the sensor is mounted and the sensor and board wiring is complete:
1.Attach the sensor circuit board enclosure to the mounting plate. Push the top of the front part onto the mounting plate so the hooked mounting tabs fit underneath the circuit board enclosure, and push the bottom part down so that the three prongs on the back of the circuit board fit into the wiring connector. Continue pushing until the front part is flush with the mounting plate.
2.Replace the front cover by inserting the hooked tab at the top of the cover into the slot on the front of the circuit board enclosure so that it snaps into place. Press the bottom of the cover until it snaps into the enclosure.
NOTE: Do not expose sensor element to the fumes of curing RTV silicone rubber. Doing so will damage the calibration of the element.
EmersonTM, Emerson. Consider It SolvedTM and Emerson Climate TechnologiesTM logos are trademarks and service marks of Emerson Electric Co.
Intelligent StoreTM is a trademark of Emerson Climate Technologies. All other trademarks are the property of their respective owners.
© 2011 Emerson Climate Technologies, Inc. All rights reserved.
31