Carbon Dioxide Sensor
Product Information Sheet |
|
Overview
CPC’s CO2 sensor (P/N
An LCD display is available to provide local indication of CO2 concentration and facilitate the setup and calibration process. An adjustable setpoint relay is available for direct control and alarm applications.
Mounting
Before mounting, remove the door from the circuit board by pressing a screwdriver against the locking tab on the top of the enclosure. Pry the circuit board
away from the mounting plate using a screwdriver inserted into the two tab slots on the top of the enclosure.
Choose a location for the sensor with good air circulation, away from ventilation inlets, doors, windows, or other points where fresh air enters the room. The sensor should be mounted at least
If wiring will be coming in through the mounting plate from the back, punch out openings in the mounting plate and use the plate as a template for locating holes. Mount the mounting plate against a wall or other flat surface by using the two mounting holes and the screws provided (use wall anchors for drywall installations).
NOTE: Sensors must be mounted vertically (straight up and down) to ensure proper readings.
Figure 1 - CO2 Sensor (exploded view)
40