Emerson Torque Arm Assembly Instructions, Mounting Instructions, Series 3000 Torque Arm Kits

Torque Arm Assembly Instructions

Mounting Instructions

1.  For Series 3000, mount the torque arm as shown in Figure 5 to side of the reducer where the driven shaft enters.  Apply Loctite* 432 or equal to the threads of each bolt before assembly.

2.  Connect the reducer to the driven shaft.

3.  Attach torque arm to the mounting plate or attachment point. 4.  Tighten the cap screws to the recommended torque.

Series 3000 Torque Arm Kits

Table 1

OtN Frame	Kit Part ID#
31	ROC100KT001
32	ROC200KT001
33	ROC300KT001
34	ROC400KT001
35	ROC500KT001
36	ROC600KT001
37	ROC700KT001
38	ROC800KT001

Table 2

Fastener Size	Torque ( Ft. Lbs)
M10	49
M12	87
M16	220
M20	430
	90°

Table 3

OtN Frame(s)	Kit Hardware
31 and 32	Screws (4)
	Roll Pin (1)
33, 34, 35	Screws (3)
	Roll Pin (1)
36 and 37	Screws (4)
	Roll Pin (1)
38	Screws ( 8 )
	Roll Pin ( 2 )

180°

0°

Anchoring of the

Torque Arm

(Top View)

270°

Figure 5

* The following trade names, trademarks and/or registered trademarks are used in this material by Emerson Power Transmission Corporation are NOT owned or controlled by Emerson Power Transmission Corporation and are believed to be owned by the following parties: LOCTITE: Henkel Corporation. Emerson Power Transmission Corporation cannot and does not represent or warrant the accuracy of this information.

11