4.The installation of the
Figure 5 Installation of hold-down clips in pairs
a. One pair every 6 to 8 feet in straight patterns (see Figure 6). b. One pair every 3 to 4 feet in circular patterns (see Figure 7).
c.One pair at the beginning and end of the arc when turning 90 degrees (see Figure 8).
d.One pair as needed to maintain consistent uniform contact between the floor and detection cable.
Figure 6 Cable laid in straight patterns
Figure 7 Cable laid in circular patterns
Figure 8 90° turn in cable
5.Be certain the detection cable is protected from the adhesive instal- lation for the
6.Once adhesive is completely dry, snap the cable into each
7.Check that there are no gaps between the floor and detection cable. (Add clips as required.)
8.Be certain there are no alarms present on the module.
9.Do final testing as per instruction in Step 2.
9