5
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF110
1/4-20 x 1/2" FLANGE SCREWS WITH
LOCKWASHERS PRE-ASSEMBLED (2)
FLANGE/BLADE ASSEMBLY
MOTOR HUB
Figure 4
FINIAL
Figure 5
FAN MOTOR HOUSING
KNURLED RETAINER
SCREW (4)
UPPER GLASS
RETAINER
Figure 7
GLASS SHADE
FAN MOTOR HOUSING
LOWER GLASS
RETAINER
Figure 6
NOTE: Take care not to scratch fan housing when
installing blades.
4. Attach the flange/blade assembly to the motor hub
using the two pre-installed 1/4-20 x 1/2” flange
screws and lockwashers. Make sure the screws are
tightened securely (Figure 4). Repeat this procedure
for the other four blade assemblies.
5. Screw the finial onto the center threaded stud of the
motor housing until securely tighten (Figure 5).
6. Carefully turn the partially assembled fan right side
up in preparation of final installation. Rest the fan
motor housing onto the packing styrofoam, being
careful not to bend the blades.
7. Carefully place the glass shade over the fan motor
housing, resting it into the lower glass retainer.
Orintate the glass shade so that the larger lip is
resting in the lower glass retainer per Figure 6.
8. Remove the four knurled retainer screws from the
motor housing and retain for future use.
9. Align the four holes of the upper glass retainer onto
the fan motor housing and reinstall the four knurled
retainer screws (previously removed). Securely
tighten all four screws (Figure 7).