Emerson CF110BS00, CF110ORB00 owner manual Wall Control Installation

Wall Control Installation

!WARNING

Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.

CAUTION: To reduce the risk of electrical shock, disconnect the electrical supply circuit before installing the fan, light kit or receiver.

This control is designed to operate only one ceiling fan, (Figure 18). This SW46 speed control is rated for 1.2 amps at 120 volts..

1.Before disconnecting power, ensure that the fan is set at the highest speed.

NOTE: Electric connections should be in accordance with the National Electrical Codes and all Local Codes. Before starting, disconnect power to the circuit at the fuse box or circuit breaker panel.

2.Remove the faceplate and screws from the existing wall switch. Pull switch out from wall outlet box.

3.Disconnect wire from existing fan wall switch (Figure 19).

4.Slide the SW46 speed control in the OFF position (0).

5.Connect one BLACK wire from the SW46 speed control to the fan/motor lead with a wire connector (provided). (Figure 20.)

6.Connect the other BLACK wire from the SW46 speed control to the 120VAC hot wire with a wire connector (provided).

NOTE: Use wire connectors (supplied) to secure electrical connections.

7.Attach the SW46 speed control to the wall outlet box with two 6-32 x 3/4” screws (provided).

4

3

2

1

0

Figure 18

	WALL
SWITCH	OUTLET
	BOX
FACEPLATE
Figure 19

TO NEUTRAL	TO FAN MOTOR LOAD
	MOTOR LOAD
	1.2 AMP MAXIMUM
	BLACK
4	BLACK
3
2
1
0
	TO
	120VAC
Figure 20	SOURCE
	HOT

10 ETL Model No.: CF110