Emerson CF180AP00 owner manual To avoid possible fire or shock, make

BP7357 CF180 BRIDGETON 9/19/07 11:21 AM Page 10

	STANDARD ON-OFF WALL
	SWITCH OR OPTIONAL SW101
	WALL CONTROL	BLACK
TO	BLACK
	(HOT)		BLACK
120-
VOLT			WHITE
SUPPLY	WHITE
		WHITE

		GROUND	RED
		TWO-CONDUCTOR	BLUE		WHITE
		CABLE (WITH
		GROUND)
		GREEN WIRE (GROUND)	BLACK
			BLUE
		FROM HANGER BALL AND		WHITE
Figure 13		HANGER BRACKET
			HANGER BALL
3. Push the wires and connectors up into			!	WARNING
	the outlet box while inserting the receiv-
	er fully into the hanger bracket. Position		To avoid possible fire or shock, make
	the antenna wire on top of the receiver.		sure that the electrical wires are
4.	Screw the two 1-1/4” threaded studs		completely inside the outlet box and
			not pinched	between the ceiling
	(supplied) into the tapped holes in the
			cover and the ceiling.
	hanger bracket (Figure 12).
5.	Lift the ceiling cover up to the threaded		7. Screw three 60-watt (maximum) cande-
	studs and turn until the studs protrude		labra base flame bulbs into the light
	through the holes in the ceiling cover		fitter sockets (Figure 15).
	(Figure 14).
6. Secure the		ceiling cover in place by
	sliding lockwashers (supplied) over the
	threaded studs and installing the two				LIGHT
	knurled knobs (supplied). (Figure 14).
	Tighten the	knurled knobs securely	60-WATT		FITTER
	until the ceiling cover fits snugly against
			CANDELABRA
	the ceiling.		BASE BULB (3)		ARM
				RING
		CEILING	CHANNEL
		COVER		SCREWS (6)
			LOWER
			GLASS		LOWER RING
			Figure 15
					ASSEMBLY
LOCKWASHER		THREADED	8. Unscrew the six ring screws from the
(2)		STUD (2)	lower ring assembly (Figure 15).
KNURLED			Position the lower glass in the lower
KNOB (2)			ring assembly so that the six channels
Figure 14			in the glass align with the six arms of

the lower ring assembly.

10 U.L. Model No.: CF180