Installation of Ceiling Cover (Standard)
1.Lift the ceiling cover up to the threaded studs and turn until the studs protrude through the holes in the ceiling cover (Figure 18).
! WARNING
To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.
2.Position the lower ceiling cover trim ring onto the threaded studs and secure both the ceiling cover and ring in place by sliding lockwashers (supplied) over the threaded studs and installing the two knurled knobs (supplied). (Figure 18). Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling.
| CEILING |
| COVER |
| CEILING COVER |
| TRIM RING |
| THREADED STUD (2) |
| LOCKWASHER (2) |
Figure 18 | KNURLED KNOB (2) |
Close-to-the-Ceiling Installation
Installing The Ceiling Cover On The Fan Motor Housing
1.Remove and retain three screws from the top of the motor housing (Figure 19A).
2.Position the rubber gasket (supplied in parts bag) on the motor housing (small holes in gasket centered over the screw holes in the housing) (Figure 19B).
3.Remove the ceiling cover trim plugs
4.Align the holes in the ceiling cover with the holes in the motor housing and secure using the three screws (Figure 21).
5.The fan comes with blue, black and white leads that are 80” long. Measure up approximately 6 to
REMOVE SCREWS (3) INSTALL RUBBER GASKET
Figure 19A | Figure 19B |
CEILING COVER
CEILING COVER
TRIM PLUG (2)
Figure 20
RUBBER | SCREW (3) |
| |
GASKET |
|
Figure 21
11 | U.L. Model No.: CF230 |