Emerson CF230BS00, CF230ORB00, CF230WW00 owner manual Loosen TWO

Installation of Hanger Bracket (continued)

! WARNING

Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.

1.Disconnect electrical power to the branch circuit at the circuit breaker or fuse box before attempting to install the ceiling fan mounting plate on the outlet box.

2.Loosen (but do not remove) the two mounting screws in the outlet box (Figure 2). Position the hanger bracket on the outlet box so that the T-slots in the hanger bracket are aligned with the outlet box screws.

	OUTLET BOX
	LOOSEN TWO
T-SLOT	SCREWS (SUPPLIED
	WITH OUTLET BOX)
	SLIDE THE HANGER
	BRACKET ONTO
	THE OUTLET BOX
	SCREWS, THROUGH
	THE T-SLOT
	HANGER
	BRACKET
Figure 2

NOTE: The hanger bracket must be mounted flush with the ceiling in order for the ceiling cover to install properly. If necessary, use leveling washers (not supplied) between the outlet box and the hanger bracket.

3.Slide the hanger bracket onto the outlet box screws. Center the bracket over the outlet box and then securely tighten the screws (Figure 3).

! WARNING

Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall.

SECURELY TIGHTEN

SCREWS

HOOK HANGER BRACKET

Figure 3

5 U.L. Model No.: CF230